Skip to main content

Gallery


(1) Intersession 2022/University of Scranton: Designed a 3.3 V DC power breakout board to help my students connect a BBC micro:bit on a breadboard!!! I have used the newly released KiCad 6 to design this board and I really liked working with KiCad, so now going to fully switch from DipTrace to KiCad. 

Eagerly waiting for the delivery from OSH Park!


(2) A MMIC PA on-wafer characterization (University of Calgary)


(Ref: https://ieeexplore.ieee.org/abstract/document/9303362)





Comments

Post a Comment

Popular posts from this blog

Import ADS Gerber Files in DipTrace

Import ADS Gerber Files in DipTrace
Post a Comment
Read more

Add a ground tab on top PCB layer in DipTrace

Add a ground tab on top PCB layer in DipTrace
Post a Comment
Read more

How to connect the PICkit4 programmer to a PIC MCU

The Microchip's MPLAB PICkit4 In-Circuit Programmer (ICSP) should be connected to a PIC MCU as shown in the following diagram. The programmer has 8 pins but only the first 5 pins are used for this connection. The pin number 1 on the programmer can be identified with the arrow symbol on the program as shown below. (PICkit4 Programmer*) Short male-to-male jumper wires can be used to create the 5-wire connection as follows. The programming might be successful without connecting the recommended 50 kohm resistor between the MCLR and VDD pins, but it is a good idea to follow the recommendations. *  The Microchip name and logo, the Microchip logo, MPLAB and PICkit are registered trademarks of Microchip Technology Incorporated in the U.S.A. and other countries.
Post a Comment
Read more